Aluminium Casting Leak Test Machine
A dedicated test system for detecting leakage in aluminium die-cast components, configurable for a range of test methods and component geometries.
Water, tub, exhaust, hose/tube, differential and compressor leak testers
Leak Testing Machine Manufacturer in Noida, India | Wellman
A dedicated test system for detecting leakage in aluminium die-cast components, configurable for a range of test methods and component geometries.
A dependable test station for detecting leakage in hoses and tubes, delivering consistent and repeatable results.
A purpose-built machine for the leak testing of tubes, hoses and condensers, combining ease of operation with highly reliable inspection.
Automatic leak and pressure testing equipment that enables efficient, high-throughput handling of the leak test operation.
A fully automatic leak test system for washing-machine tubs, controlled by a PLC panel for consistent, operator-independent results.
An automatic leak test machine for two-wheeler exhaust pipes, well designed for reliable in-line quality inspection.
An automatic air leak tester that detects leaks through minute changes in differential pressure and delivers a clear OK / NG judgement. Ideal for integration into production lines for quality control.
A test system for detecting leaks in compressors, providing an accurate measurement of the leakage rate.
Tests the leak-tightness and structural integrity of boilers, pressure vessels, metal castings, pipes and tubes under hydraulic pressure.
Specifications shown are from Wellman supplies; every machine is built to the customer’s requirement. Images marked “Illustrative image” show typical applications.
Buyer Questions
We make hose and tube, tube and condenser, water (WLT), tub, exhaust pipe, aluminium casting, compressor, differential pressure and hydraulic pressure testing machines.
Parts are tested underwater in an SS-304 tank (2,500 × 800 × 400 mm) at dual pressure: 5 to 10 kg/cm² for 10 seconds, then 35 to 45 kg/cm² for 20 seconds. Three components are tested per cycle, controlled by a Mitsubishi PLC with a 7-inch HMI.
An automatic air leak tester that detects leaks through very small changes in differential pressure and gives a clear OK / NG result. We use Fukuda or ATEQ leak detectors with a Mitsubishi PLC.
From 0.2 bar air for washing machine tubs up to 45 kg/cm² nitrogen for tubes and condensers, 30 bar for compressors and 400 bar for hydraulic pressure testing.
Typically 20 to 60 seconds, depending on the component, test method and pressure.
All our conveyors, assembly lines, leak testers, SPMs, lifts and storage systems in one PDF.